PROGRAMMING
B–63604EN/01
4. INTERPOLATION FUNCTIONS
51
In the cylindrical interpolation mode, positioning operations (including
those that produce rapid traverse cycles such as G28, G80 through G89)
cannot be specified. Before positioning can be specified, the cylindrical
interpolation mode must be cancelled. Cylindrical interpolation (G07.1)
cannot be performed in the positioning mode (G00).
In the cylindrical interpolation mode, a workpiece coordinate system
G50 cannot be specified.
In the cylindrical interpolation mode, the cylindrical interpolation mode
cannot be reset. The cylindrical interpolation mode must be cancelled
before the cylindrical interpolation mode can be reset.
Canned cycles for drilling, G81 to G89, cannot be specified during
cylindrical interpolation mode.
Mirror image for double turret, G68 and G69, cannot be specified during
cylindrical interpolation mode.
D Positioning
D Coordinate system
setting
D Cylindrical interpolation
mode setting
D Canned cycle for drilling
during cylindrical
interpolation mode
D Mirror Image for Double
Turret