17. MEMORY OPERATION BY
Series 10/11 TAPE FORMAT
B–63604EN/01
PROGRAMMING
314
Drilling cycle
G81X_C_Z_F_L_ ; or G82X_C_Z_R_F_L_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Peck drilling cycle
G81X_C_Z_R_Q_P_F_L_ ;
R : Distance from the initial level to the R position
Q : Depth of cut in each cycle
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
High–speed peck drilling cycle
G83.1X_C_Z_R_Q_P_F_L_ ;
R : Distance from the initial level to the R position
Q : Depth of cut in each cycle
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Tapping
G84X_C_Z_R_P_F_L_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Rigid tapping
G84.2X_C_Z_R_P_F_L_S_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
S : Spindle speed
Boring cycle
G85X_C_Z_R_F_L_ ; or G89X_C_Z_R_P_F_L_ ;
R : Distance from the initial level to the R position
P : Dwell time at the bottom of the hole
F : Cutting feedrate
L : Number of repetitions
Cancel
G80 ;
For this CNC tape format, the address used to specify the number of
repetitions is K. For the FS10/11 tape format, it is L.
17.6
CANNED DRILLING
CYCLE FORMATS
Format
Explanations
D Address