
12
50
FANUC Series 16i-TB
2 CPU 3-path control function
Specifications
-78884E
ED. DATE DESIG. DESCRIPTION
TITLE
DRAW.NO.
01 Aug.01.’02 Newly registered
SHEET
(3) Composite Control
Move commands can be interchanged between an axis in path 1 or path 2 and an axis in the
other path. In other words, when a machining program is executed for one path, actual
machining can be performed with an axis in the other path. Coordinate systems can also be
switched automatically between independent control and composite control.
(a) Setting
Parameter No.8183 specifies the axes between which commands are to be interchanged.
(Example)
Between the X1-axis and the X3-axis:
Parameter No.8183x of path 3 = 11
Between the Y2-axis and the X1-axis:
Parameter No.8183x of path 1 = 24
Between the Z3-axis and the Y2-axis:
Parameter No.8183y of path 2 = 32
To set up coordinate systems automatically when composite control begins or ends, set
parameter MPMx and MPSx (bit4 and bit5 of parameter No.8162) to "1", and specify the
positional relationship between the coordinate systems in parameter No.8184.
(b) Programming
Use M codes for wait, beginning, and terminating composite control in a machining
program in the stated order. It is also possible to begin and terminate composite control
without using M codes.
(c) Signal operation
When composite control begins or ends (when an M code is issued), the composite control
axis selection signals (MIX1-MIX8) for the target axis to set the parameter as the
composite control axis (from the PMC to the CNC) are changed from "0" to "1" (to begin
composite control) or from "1" to "0" (to end composite control).