
26
50
FANUC Series 16i-TB
2 CPU 3-path control function
Specifications
-78884E
ED. DATE DESIG. DESCRIPTION
TITLE
DRAW.NO.
01 Aug.01.’02 Newly registered
SHEET
(7) Alarms and Messages
If one of the alarms listed below occurs, it terminates synchronous, composite, and
superimposed control for all axes.
Number Message Description
225 Synchronous or composite
control error.
This alarm occurs under either of the following
conditions(detected when synchronous,
composite, or superimposed control is
terminated).
(1) There is an error in an axis number
parameter (parameter No.1023).
(2) An invalid control command is issued.
If this alarm occurs when synchronous,
composite, or superimposed control is terminated,
place the machine in an emergency stop state
before resetting the alarm.
226 A move command was issued to
a synchronous axis.
When an axis is in a synchronous mode, a move
command was issued to that axis. (Only during
synchronous control)
During composite control, a move command was
issued to an axis for which parameter MUMx
(bit7 of parameter No.8162) is "1". (Only during
composite control)
In a control mode other than synchronous or
composite control, a move command was issued to
an axis for which parameter NUMx (bit7 of
parameter No.8163) was "1".
229 Synchronization cannot be
maintained.
This alarm occurs under either of the following
conditions.
(1) Synchronous or composite control cannot be
maintained because of system overload.
(2) Synchronous or composite control cannot be
maintained because of a hardware failure.
(This alarm does occur during normal use.)
000 Turn the power off
This message is issued if superimposed control is
suspended because of an alarm that occurs when
the axis is moving. Turn the power of the CNC
off, then on again.
407 Servo alarm: Excessive error
A positional deviation for asynchronous axis
exceeded the specified value. (Only during
synchronous control)