
PROGRAMMING
B–64144EN/01
19. HIGH SPEED CUTTING
FUNCTIONS
363
Name Function
High–speed skip function (G31) f (*1)
Multi–step skip function (G31 Px) f (*2)
Reference position return (G28) f (*1)
To execute G28 in the status in which the refer-
ence position is not established, set bit 2 (ALZ)
of parameter No. 7055 to 1.
Reference position return check
(G27)
f (*1)
2nd, 3rd, and 4th reference posi-
tion return (G30)
f (*1)
Feed functions f : Can be specified. : Cannot be specified.
Name Function
Up to 240 m/min (0.001 mm)
Up to 100 m/min (0.0001 mm)
Rapid traverse rate override F0, 25, 50, 100 %
Rapid traverse rate override in in-
crements of 1%
0 to 100 %
Feed per minute (G94) f
Feed per revolution (G95)
Cutting feedrate clamp f
Bell–shaped acceleration/decel-
eration for rapid traverse
f
Linear acceleration/deceleration
after cutting feed interpolation
f
Linear acceleration/deceleration
before cutting feed interpolation
f (Up to 12 blocks are read in advance in the AI
contour control mode.)
Feedrate override 0 to 254 %
Single–digit F code feed f To enable feedrate change using a manual
handle, set bit 1 (AF1) of parameter No. 7055
to 1.
Override cancel f
External deceleration f
Program input f : Can be specified. : Cannot be specified.
Name Function
Control in/control out command () f
Optional block skip command
(/n: n is a number.)
f
Absolute command (G90)/
incremental command (G91)
f
Decimal point programming/pock-
et calculator type decimal point
programming
f
10–fold input unit f
Plane selection (G17, G18, G19) f
Polar coordinate command (G16)
Local coordinate system (G52) f (*1)
Machine coordinate system (G53) f (*1)
Workpiece coordinate system
(G54 to G59)
(G54.1Pxx)
f
Workpiece coordinate system
(G92)
f (*1)
Workpiece coordinate system pre-
set (G92.1)
f (*1)