
APPENDIX
B–64144EN/01
G. ALARM LIST
825
No. DescriptionFaulty location and remedy
SVPM
STATUS1
indica-
tion(*1)
Message
7n42 SPN_n_ : NO 1–ROT.
POS–CODER
DETECT
42 Replace the cable. The 1–rotation signal of the spindle
position coder (connector JYA3) is
disconnected.
7n46 SPN_n_ : SCREW
1–ROT POS–
COD. ALARM
46 1 Check and correct the parame-
ter.
2 Replace the cable.
An abnormality equivalent to alarm 41
was detected during thread cutting
operation.
7n47 SPN_n_ : POS–CODER
SIGNAL AB-
NORMAL
47 1 Replace the cable.
2 Correct the cable layout (vicin-
ity of the power line).
1 The A/B phase signal of the
spindle position coder (connector
JYA3) is abnormal.
2 The relationship between the A/B
phase and 1–rotation signal is in-
correct (Pulse interval mismatch).
7n50 SPN_n_ : SPNDL CON-
TROL OVER-
SPEED
50 Check whether the calculated val-
ue exceeds the maximum motor
speed.
In spindle synchronization, the speed
command calculation value exceed-
ed the allowable limit (the motor
speed is calculated by multiplying the
specified spindle speed by the gear
ratio).
7n51 SPN_n_ : LOW VOLT DC
LINK
51 1 Check and correct the power
supply voltage.
2 Replace the MC.
Input voltage drop was detected.
(Momentary power failure or poor MC
contact)
7n52 SPN_n_ : ITP SIGNAL
ABNORMAL I
52 1 Replace the SVPM control
printed circuit board.
2 Replace the spindle interface
printed circuit board in the CNC.
NC interface abnormality was de-
tected (the ITP signal stopped).
7n53 SPN_n_ : ITP SIGNAL
ABNORMAL II
53 1 Replace the SVPM control
printed circuit board.
2 Replace the spindle interface
printed circuit board in the CNC.
NC interface abnormality was de-
tected (the ITP signal stopped).
7n54 SPN_n_ : OVERLOAD
CURRENT
54 Review the load state. An overload current was detected.
7n58 SPN_n_ : OVERLOAD IN
SVPM
58 1 Check the SVPM cooling sta-
tus.
2 Replace the SVPM unit.
The temperature of the radiator has
increased abnormally.
7n73 SPN_n_ : MOTOR SEN-
SOR DISCON-
NECTED
73 1 Replace the feedback cable.
2 Check the shield processing.
3 Check and correct the connec-
tion.
4 Adjust the sensor.
The motor sensor feedback signal is
not present.
7n74 SPN_n_ : CPU TEST ER-
ROR
74 Replace the SVPM control
printed–circuit board.
An error was detected in a CPU test.
7n75 SPN_n_ : CRC ERROR 75 Replace the SVPM control
printed–circuit board.
An error was detected in a CRC test.
7n79 SPN_n_ : INITIAL TEST
ERROR
79 Replace the SVPM control
printed–circuit board.
An error was detected in an initial test
operation.