
B-65272EN/04 SPECIFICATIONS FOR THE αi SERIES 4.NOTES ON INSTALLATION
- 15 -
3 Cable wiring
Follow the procedure below to install the cable.
(1) Use a hammer to strike the portion for the cable hole on the
terminal box and open the hole.
This time, pay attention not to break the other place except
hole. (In some models, it is not necessary to make a hole.)
(2) Thread the cable through a conduit. Connect the conduit
with the connector. (*1)
(3) Tighten the connector at the cable hole of the terminal box
using a nut. (*2, *3)
(4) Connect each terminal appropriately in the terminal box
with screws.
When a hole once made is not used, purchase the following
rubber bushing and mount it at the hole.
Do not open a hole where it is not required.
Break the thin plastic plate to make a hole.
Model Ordering number
α1i to α15i , α12iP to α22iP
α1.5/15000iT to α15/10000iT
α6HVi to α22HVi
α15HVi
P , α22HViP
α1.5/15000HViT to α22/10000HViT
α8/20000iL , α8/20000HViL
A06B-0754-K001
α18i, α22i, α30iP, α40iP, α50iP
α40HViP , α50HViP
α15/12000iT, α22/10000iT
α15/15000iL, α26/15000iL
α15/15000HViL, α26/15000HViL
A06B-0731-K001
High-speed models are same as above.