
B-65272EN/04 SPECIFICATIONS FOR THE αi SERIES 4.NOTES ON INSTALLATION
- 27 -
4.4 WHEN A MOTOR IS CONNECTED TO A SPINDLE VIA A
BELT
CAUTION
1 Mounting the pulley
- The gap between the inner surface of the motor pulley and
output shaft should be 10µm to 15µm.
- If the gap is large when the high-speed rotation (4500 min
-1
),
fretting produced at the gap causes a large vibration,
resulting in damage to the motor bearing.
- As the vibration is intensified, fretting occurs in the gap
mentioned above, and the pulley and shaft can stick to each
other.
- To secure a pulley, use a friction-tightening part such as a
SPANN ELEMENTE or clamping sleeve.
NOTE
The SPANN ELEMENTE RfN8006 is manufactured
by RINGFEDER.
The clamping sleeve DSM is manufactured by
SPIETH.
Example 1 Two sets of SPANN ELEMENTE RfN8006 are used.
The collar is pinched at two points by the two sets.
Example 2 Clamping sleeve DSM is used.
SPANN ELEMENTE
SPANN ELEMENTE
2 After attaching a pulley to the motor, adjust the vibration of the
belt groove to within 20 µm (T.I.R).
5 Before the belt is looped, FANUC recommends that the dynamic
balance (field balance) be corrected.