
B-65272EN/04 FANUC AC SPINDLE MOTOR αi SERIES 2.SPECIFICATIONS
- 55 -
(*1) For α6/12000i, α8/10000i, α12/10000i, α15/10000i,
α18/10000i, and α22/10000i, the CNC soft option and
switching magnetic contactor unit associated with the output
switch function (Y-∆ switch) are required.
See FANUC SERVO AMPLIFIER αi series DESCRIPTIONS
(B-65282EN) for details of the output switch control.
(*2) The rated output is guaranteed at the rated voltage.
(Amplifier input: 200/220/230V AC +10% -15%, 50/60 Hz
±1Hz)
If the input voltage fluctuates, it is possible that the rated output
cannot be obtained even when such fluctuations are within the
allowable fluctuation range.
(*3) The output for α0.5/10000i, α1/10000i, α2/10000i, α1/15000i,
α1.5/15000i, or α2/15000i is 15 min rated. That for
α1.5/10000i is 10 min rated.
(*4) S3 40% for α0.5/10000i, α30/6000i, α50/4500i, α1/15000i,
α1.5/15000i, or α2/15000i, S3 25% for α1.5/10000i.
(*5) The cycle time is 10 minutes, S3 60%: ON 6 minutes, OFF 4
minutes, S3 40%: ON 4 minutes, OFF 6 minutes and S3 25%:
ON 2.5 minutes, OFF 7.5 minutes.
(*6) The rated current is not a guaranteed value but a guideline for
the maximum current at rated output.
(*7) IC code conforms to IEC 34-6.
(*8) IM code conforms to IEC 34-7. When using α1/15000i,
α1.5/15000i, or α2/15000i, the output shaft must be placed
horizontally or vertically downward (IMB5, IMV1).
(*9) This is not a guaranteed value but a guideline for the maximum
motor output at a rated supply voltage. 120 % of 15 min rated
for α0.5/10000i, α1/10000i, α2/10000i, α1/15000i,
α1.5/15000i, or α2/15000i and 120% of 10 min rated for
α1.5/10000i.
(*10) Type conforms to IEC 34-11.
(*11) These values are to be used only as guidance for selecting a
power supply module and are not guaranteed.
(*12) There is another type of α3/12000i that has a built-in Mi
sensor.
(*13) Degree of protection:
with oil seal: IP54, without oil seal: IP40.