Detail
number
MeasureCause
Parameter
number
1393 2139 The setting of the linear motor AMR offset
has exceeded ±45.
Decrease the setting of the parameter
listed at the left to within ±45.
1446
1447
1448
2144 The cutting feedforward coefficient for the
cutting–/rapid traverse–specific FAD func-
tion has overflowed.
Use the position gain magnification func-
tion.
1454
1455
1456
1459
2145 The cutting velocity feedforward coeffi-
cient for the cutting–/rapid traverse–spe-
cific FAD function has overflowed.
Decrease the velocity feedforward coeffi-
cient.
8213 1821 No positive value has been set in the ref-
erence counter capacity parameter.
Specify a positive value in the parameter
listed at the left.
8254
8255
8256
1825 The internal value of the position gain has
overflowed.
Use the position gain magnification func-
tion.
10016
10019
2200 bit 0 The internal value of a parameter used to
detect runaway has overflowed.
Do not use the runaway detection func-
tion (specify bit 0 = 1).
10043 1815#1
2010#2
A full–closed loop has been set up for a
linear motor (except for the Series 9080).
A full–closed loop cannot be specified for
linear motors.
10053 2018#0 The scale reverse connection bit has
been set up for a linear motor.
The scale reverse connection bit cannot
be used for linear motors.
10062 2209#4 The amplifier in use does not support the
HC alarm avoidance function.
If you want to use this amplifier, reset the
function bit listed at the left to 0.
If you want to use the HC alarm avoidance
function, use an amplifier that supports it.
360 Cumulative command pulse count (NC)
DGN
[Data type] Two–word axis
[Unit of data] Detection unit
[Valid data range] –99999999 to 99999999
Indicates the cumulative count of movement commands distributed from
the CNC since the power was switched on.
361 Cumulative compensation pulse count (NC)
DGN
[Data type] Word axis
[Unit of data] Detection unit
[Valid data range] –32767 to 32767
Indicates the cumulative count of compensation pulses (backlash
compensation, pitch error compensation, etc.) distributed from the CNC
since the power was switched on.
D Error detection
1. DISPLAY AND OPERATION
GFKE-0222-EN
78