12.Press address O and a program number (0001 for example) ,then press
DELETE
to delete the program.
Item 4 is not required for PPR.
1. Select the EDIT mode.
2. Turn off the program protect (KEY=1).
3. Press
PROG
key, and press soft key[PRGRM] to display the program
contents screen.
4. Press soft key [(OPRT)],
, [F SRH], and
5
[EXEC] to select
the tool compensation amount file.
5. Press
OFFSET
SETTING
key, and soft key [OFFSET] to display the tool
compensation amount screen.
6. Press soft key [(OPRT)] and key.
7. Press [READ] key and [EXEC] key and data input is started.
Confirm the following parameters. If the setting is different from the
value indicated by l, reset to the specified value only during this work.
(Change it in MDI mode).
#7
3201
#6
NPE
#5 #4 #3 #2 #1
RAL
#0
#6 (NPE) When programs are registered in part program storage area, M02,M30
and M99 are:
0 : regarded as the end of program.
l 1 : not regarded as the end of porgram.
#1 (RAL) When programs are registered:
l 0 : All programs are registered.
1 : Only one program is registered.
#7
3202
#6 #5 #4
NE9
#3 #2 #1 #0
NE8
#4 (NE9)
l 0 : Programs of 9000s can be edited.
1 : Programs of 9000s are protected.
#0 (NE8)
l 0 : Programs of 8000s can be edited.
1 : Programs of 8000s are protected.
6.2.12
Inputting Tool
Compensation Amount
6.2.13
Inputting Part Programs
GFKE-0222-EN
6. INPUT AND OUTPUT OF DATA
409