5 Set the parameters corresponding to the type of input/output unit to be
used. (Parameter setting is possible regardless of the mode.)
Tip
First, set an I/O channel. The parameters on this screen change to those
corresponding to a specified I/O channel.
D I/O channel (0 to 3)
Setting Corresponding parameter
0 No. 101 to 103
1 No. 111 to 113
2 No. 121 to 123
3 No. 131 to 135
D Device number
Setting Input/output device
0 RS–232–C (The control codes DC1 through DC4 are used.)
1 FANUC CASSETTE ADAPTOR 1 (FANUC CASSETTE B1/B2)
2 FANUC CASSETTE ADAPTOR 3 (FANUC CASSETTE F1)
3 FANUC PROGRAM FILE MATE, FANUC FA Card Adaptor
FANUC FLOPPY CASSETTE ADAPTOR, FANUC Handy File
FANUC SYSTEM P–MODEL H
4 RS–232–C (The control codes DC1 through DC4 are not used.)
5 Portable tape reader
6 FANUC PPR
FANUC SYSTEM P–MODEL G, FANUC SYSTEM P–MODEL H
D Baud rate (bps)
Set a desired baud rate value indicated below.
Baud rate (bps)
50
100
110
150
200
300
600
1200
2400
4800
9600
19200
6. INPUT AND OUTPUT OF DATA
GFKE-0222-EN
424