Y–AXIS FAPT FUNCTION
B–61804E–2/05
4. DEFINING MACHINING
(MENU 4)
254
WARNING
The cutting conditions are automatically set according to the
selected machining type. Check the set conditions. If the
conditions are incorrect, the tool may collide with the
workpiece and/or machine, or forced machining may occur,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
1) Cutting conditions
Enter the following cutting conditions for the machining:
a. Y–axis center drilling
DEPTH OF CUT: D1 = Depth of cut (mm)
CLEARANCE: C1 = Clearance 1 (mm)
RPM: N = Tool rotational speed (rpm)
FEEDRATE: FT = Feed amount per revolution of the tool
(mm/rev)
b. Y–axis drilling
b–1. Drilling method 1
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
DWELL ON/OFF:DW =1 for dwell at the bottom of the
hole, 0 for no dwell
RPM: N = Tool rotational speed (rpm)
FEEDRATE: FT = Feed amount per revolution of the
tool (mm/rev)
b–2. Drilling method 2
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
RETRACTION: U = Retraction distance (mm)
DEPTH OF CUT: D1 = Depth of cut (mm)
RPM: N = Tool rotational speed (rpm)
FEEDRATE: FT = Feed amount per revolution of the
tool (mm/rev)
b–3. Drilling method 3
CLEARANCE: C1 = Clearance 1 (mm)
C2 = Clearance 2 (mm)
C3 = Clearance 3 (mm)
DEPTH OF CUT: D1 = Depth of cut (mm)
RPM: N = Tool rotational speed (rpm)
FEEDRATE: FT = Feed amount per revolution of the
tool (mm/rev)
4.4
CUTTING
CONDITIONS