B–61804E–2/05
B. RESTRICTIONS ON EACH SYSTEM
APPENDIX
91
B
RESTRICTIONS ON EACH SYSTEM
The following tables list the functions and parameters not supported by
the models/series.
Model Series
FANUC Series 16–TA CAP II
FANUC Series 16–TTA CAP II
(1)Unsupported functions
Heading Unsupported function
III 3.2.2 Part figure input (Input method with
figure)
Trapezoidal groove definition
III 3.2.6 Batch input functions for chamfering
and corner R
Corner R batch input
III 3.2.7 Pattern figure input function Corner necking (*1)
III 3.2.8 Function for defining the center of an
arc according to a given single
coordinate
All functions
III 3.4 Machining Definition All functions (*2)
III 3.5.6 Outputting the NC data of a multiple
thread cutting cycle
All functions
III 5.1 Balance Cutting Process Tool specification method (*3)
IV 2.5 File Data Input/Output Function All functions
VII 1.13 Outputting NC data in the FS 15/16
Format
All functions
VIII 1.4 Milling in Multiple Planes All functions
VIII 1.5 C–Axis Machining with a Machining
Plane Specified
All functions
VIII 2. MACHINING DEFINITION (MENU 4) All functions (*2)
X AUTOMATIC PROCESS
DETERMINATION FUNCTION
All functions (*4)
IX Y–AXIS FAPT FUNCTION All functions
*1 The automatic thread depth specification function for corner type 3 cut
by necking (necking for threads) is not supported.
*2 Menu 4 (machining definition) has a different definition screen layout.
See Appendix B.1 for details.