B–63173EN/03
7. CONNECTION TO FA NETWORKS
211
(2)The communication connector and the method of communication
cable connection are changed. Wires, after crimped to a special crimp
terminal with a crimping tool compliant with JIS C9711, are inserted
into a plug. When a wrong wiring is made, a rod of F1 mm can be used
for extraction. A plug (cable–side connector) is delivered with I/O
Link–II slave board B. However, a crimp terminal (A02B–0259–
K211) must be ordered separately. For line expansion, an additional
crimp terminal is required.
(3)The I/O Link–II slave board imposes a restriction on the installation
and removal of the base printed circuit board of the Power Mate i. On
the other hand, I/O Link–II slave board B does not impose such a
restriction.
NOTE
1 If I/O Link–II slave board B and I/O Link–II board B of the
CNC are placed on the same line, the global I/O transfer
function does not operate normally on the I/O Link–II board
of the Power Mate i. (The DI/DO data transfer function can
operate normally.)
2 If I/O Link–II slave board B and I/O Link–II board B1/B2 of
the CNC are on the same line, the global I/O transfer
function does not operate normally on the I/O Link–II board
of the Power Mate–D/F/H. (The DI/DO data transfer
function can operate normally.)