8. CONNECTION TO SETTING AND DISPLAY UNIT
B–63173EN/03
314
The touch panel is operated by directly touching the LCD screen. For
touch panel operation, be sure to use the FANUC–supplied pen
(A02B–0236–K111) provided with the touch panel. If the LCD screen is
touched using a sharp–tipped pen, the surface of the LCD screen may be
damaged. Moreover, the LCD screen must not be touched by with your
fingers. Otherwise, the operability may be degraded, and the screen is
likely to become dirty.
A protection sheet is attached the face of an LCD with a touch panel to
protect the thin film of the touch panel and LCD. If the protection sheet
is damaged, it can be replaced. (The protection sheet is a consumable
part.)
1) Protection sheet A02B–0236–K110
2) Neutral detergent (detergent that can clean oily dirt off = detergent
for kitchen can be used)
3) Soft cloth (such as towel)
1) Before replacement
<1> Turn off the power to the machine.
<2> Peel off the old protection sheet from the surface of the touch
panel.
<3> Wipe off adhesive residue if any on the screen surface with
alcohol.
<4> Use the detergent to remove oil or dirt stuck to the surface of the
touch panel.
<5> With a soft, damp cloth, wipe off detergent completely.
D If the touch panel surface becomes cloudy, oil is still left on
the surface. Remove oil completely.
D If oil or detergent is left on the surface of the touch panel, the
protection sheet cannot adhere to the panel completely and
will sometimes peel off easily.
<6> With a dry soft cloth, wipe off moisture completely.
2) Applying the protection sheet
<1> Fold the tab over the front side (the side opposite to the backing
sheet).
Fold
<2> Peel off the backing sheet.
<3> Position the sheet, then attach the upper and lower sides of the
sheet first. Check that the sides of the protection sheet do not
touch the escutcheon.
8.9.6
Touch Panel
8.9.7
Protection Sheet for
the Touch Panel
Replacing the protection
sheet
D Materials used
D Replacement procedure