B–63173EN/03
8. CONNECTION TO SETTING AND DISPLAY UNIT
279
The detachable LCD/MDI is connected to a CNC such as the FS16, FS18,
and FS21 through the video signal/MDI signal interface as explained
below.
D Attach cables J182, J171, and J169 to the detachable LCD/MDI in
advance.
D The cables J185 and J170 must be attached to the CNC in advance.
On the relay panel, prepare connectors CA72, CA73, and CPA in
advance.
CNC
JA1
JA2
AC100V
to 240V
J185
J170
J168
J182
J171
J169
CA63
CA62
CA61
CA72
CA73
CPA
Cabinet
(such as FS16/18/21)
Video/MDI signal
interface
Relay
panel
Video signal
MDI signal
Power
Detachable
LCD/MDI
Selection switch
SW1
(1)Set selection switch SW1 on the detachable LCD/MDI to A. The
following label is stuck to selection switch SW1:
SW1
B
A
(2)Connect video signal cable J182 to connector CA72 on the relay panel.
Connect MDI signal cable J171 to connector CA73 on the relay panel.
(3)Connect power cable J169 to connector CPA on the relay panel.
(1)Detach Power cable J169 from connector CPA on the relay panel.
(2)Detach video signal cable J182 from connector CA72 on the relay
panel. Detach MDI signal cable J171 from connector CA73 on the
relay panel.
8.6.4
Connection Using the
Video and MDI Signals
Connection method
Disconnection method