B–63173EN/03
9. CONNECTION TO SERVO OR SPINDLE
369
To use servo check boards with the Power Mate i, servo check board
adaptor A02B–0236–K822 is required. This adaptor is provided with a
cable for connection to the Power Mate i.
For a detailed explanation of how to connect and use the servo check
boards, refer to the “FANUC AC SERVO MOTOR α series Parameter
Manual” or other relevant manuals.
1 A servo check board must be connected only when it is to be used. As
soon s the board is no longer needed, remove it.
2 Up to two digital servo check boards can be used at one time. If three
or more boards are to be used at one time, contact FANUC.
3 Only one analog servo check board can be used at a time. If two or
more boards are to be used at a time, contact FANUC.
4 Use the attached cable. The cable length cannot be extended.
9.6.2
Servo Check Boards
9.6.3
Notes on Use