B–63173EN/03
3. INSTALLATION
21
Diode (used for direct–current circuits)
Use a diode which can withstand a
voltage up to two times the applied
voltage and a current up to two times
the applied current.
Diode
DC relay
– +
If a cable connected to the CNC, servo amplifier, spindle amplifier, or
other device requires shielding, clamp the cable as shown below. The
clamp both supports and shields the cable. Use this clamp to ensure stable
operation of the system.
Partially peel out the sheath and expose the shield. Push and clamp by
the plate metal fittings for clamp at the part. The ground plate must be
made by the machine tool builder, and set as follows :
Cable
Metal fittings
for clamp
Ground plate
40 mm to 80 mm
Fig. 3.6.5 (a) Cable clamp (1)
Diode
3.6.5
Cable Clamp and
Shield Processing