PROGRAMMING
13. FUNCTIONS TO SIMPLIFY
PROGRAMMING
B–64124EN/01
172
Before the drilling axis can be changed, the canned cycle must be
canceled.
In a block that does not contain X, Y, Z, R, or any other axes, drilling is
not performed.
Specify P in blocks that perform drilling. If it is specified in a block that
does not perform drilling, it cannot be stored as modal data.
Do not specify a G code of the 01 group (G00 to G03 or G60 (when the
MDL bit (bit 0 of parameter 5431) is set to 1)) and G89 in a single block.
Otherwise, G89 will be canceled.
In the canned cycle mode, tool offsets are ignored.
M3 S100 ; Cause the spindle to start rotating.
G90 G99 G89 X300. Y–250. Z–150. R–120. P1000 F120. ;
Position, drill hole 1, return to point R
then stop at the bottom of the hole for 1 s.
Y–550. ; Position, drill hole 2, then return to point R.
Y–750. ; Position, drill hole 3, then return to point R.
X1000. ; Position, drill hole 4, then return to point R.
Y–550. ; Position, drill hole 5, then return to point R.
G98 Y–750. ; Position, drill hole 6, then return to the initial
level.
G80 G28 G91 X0 Y0 Z0 ; Return to the reference position return
M5 ; Cause the spindle to stop rotating.
Limitations
D Axis switching
D Drilling
D P
D Cancel
D Tool offset
Examples