OPERATION8. DATA INPUT/OUTPUT
B–64124EN/01
550
All offset data is output in a output format from the memory of the CNC
to a floppy or NC tape.
Outputting offset data
1 Make sure the output device is ready for output.
2 Specify the punch code system (ISO or EIA) using a parameter.
3 Press the EDIT switch on the machine operator’s panel.
4 Press function key
OFFSET
SETTING
, then the tool compensation screen appears.
5 Press soft key
[(OPRT)].
6 Press the rightmost soft key
(next–menu key)
7 Press soft keys
[PUNCH] and [EXEC].
Offset data is output in the output format described below.
Output format is as follows:
Format
Setting/changing the geometric compensation amount for H code
G10 L10 P_R_;
Setting/changing the geometric compensation amount for D code
G10 L12 P_R_;
Setting/changing the wear compensation amount for H code
G10 L11 P_R_;
Setting/changing the wear compensation amount for D code
G10 L13 P_R_;
The L1 command may be used instead of L11 for format compatibility of
the conventional CNC.
When the floppy disk directory display function is used, the name of the
output file is OFFSET.
8.5.2
Outputting Offset Data
Procedure
Explanations
D Output format
D Output file name