OPERATION11. SETTING AND DISPLAYING DATA
B–64124EN/01
670
Data such as the TV check flag and punch code is set on the setting data
screen. On this screen, the operator can also enable/disable parameter
writing, enable/disable the automatic insertion of sequence numbers in
program editing, and perform settings for the sequence number
comparison and stop function.
See III–10.2 for automatic insertion of sequence numbers.
See III–11.4.4 for the sequence number comparison and stop function.
This subsection describes how to set data.
Procedure for setting the setting data
1 Select the MDI mode.
2 Press function key
OFFSET
SETTING
.
3 Press soft key
[SETING] to display the setting data screen.
This screen consists of several pages.
Press page key
PAGE
or
PAGE
until the desired screen is displayed.
An example of the setting data screen is shown below.
SETTING (HANDY) O0001 N00000
> _
MDI **** *** *** 16:05:59
[ OFFSET ] [ SETING ] [ WORK ] [ ] [ (OPRT) ]
PARAMETER WRITE = 1 (0:DISABLE 1:ENABLE)
TV CHECK = 0 (0:OFF 1:ON)
PUNCH CODE = 1 (0:EIA 1:ISO)
INPUT UNIT = 0 (0:MM 1:INCH)
I/O CHANNEL = 0 (0–3:CHANNEL NO.)
SEQUENCE NO. = 0 (0:OFF 1:ON)
TAPE FORMAT = 0 (0:NO CNV 1:F15)
SEQUENCE STOP = 0 (PROGRAM NO.)
SEQUENCE STOP = 0 (SEQUENCE NO.)
SETTING (HANDY) O0001 N00000
> _
MDI **** *** *** 16:05:59
[ OFFSET ] [ SETING ] [ WORK ] [ ] [ (OPRT) ]
MIRROR IMAGE X = 0 (0:OFF 1:ON)
MIRROR IMAGE Y = 0 (0:OFF 1:ON)
MIRROR IMAGE Z = 0 (0:OFF 1:ON)
11.4.3
Displaying and
Entering Setting Data
Procedure