OPERATION11. SETTING AND DISPLAYING DATA
B–64124EN/01
650
The run time, cycle time, and the number of machined parts are displayed
on the current position display screens.
Procedure for displaying run time and parts count on the current position display screen
1 Press function key
POS
to display a current position display screen.
MEM STRT MTN *** 09:06:35
[ ABS ] [ REL ] [ ALL ] [ HNDL ] [ OPRT ]
ACTUAL POSITION(RELATIVE) O1000 N00010
PART COUNT 5
RUN TIME 0H15M CYCLE TIME 0H 0M38S
ACT.F 3000 MM/M S 0 T0000
X 123.456
Y 363.233
Z 0.000
The number of machined parts (PART COUNT), run time (RUN
TIME), and cycle time (CYCLE TIME) are displayed under the
current position.
Indicates the number of machined parts. The number is incremented each
time M02, M30, or an M code specified by parameter 6710 is executed.
Indicates the total run time during automatic operation, excluding the stop
and feed hold time.
Indicates the run time of one automatic operation, excluding the stop and
feed hold time. This is automatically preset to 0 when a cycle start is
performed at reset state. It is preset to 0 even when power is removed.
Details of the run time and the number of machined parts are displayed
on the setting screen. See III–11.4.5.
The number of machined parts and run time cannot be set on current
position display screens. They can be set by parameters No. 6711, 6751,
and 6752 or on the setting screen.
Bit 0 (PCM) of parameter 6700 is used to specify whether the number of
machined parts is incremented each time M02, M30, or an M code
specified by parameter 6710 is executed, or only each time an M code
specified by parameter 6710 is executed.
11.1.6
Display of Run Time
and Parts Count
Procedure
Explanations
D PART COUNT
D RUN TIME
D CYCLE TIME
D Display on the other
screen
D Parameter setting
D Incrementing the number
of machined parts