OPERATION12. GRAPHICS FUNCTION
B–64124EN/01
730
In solid graphics, parameter 6501 (TLC, bit 1) is used to specify whether
to apply tool length offset.
Parameter 6501 (3PL, bit 2) is used to select whether to draw a triplane
view with the third–angle or first–angle projection.
Parameter 6501 (RID, bit 3) is used to specify whether to draw ridges in
plane view drawing.
Parameter 6501 (FIM, bit 4) is used to specify whether to display a solid
graphics in the rough mode or in the fine mode. When a solid graphics
is drawn in the fine mode, the drawing speed is slower than when drawn
in the rough mode.
In triplane drawing, a value can be specified for changing the position of
the cross section while the soft key is held down. A value from 0 to 10
can be set. When 0 is specified, a value of 1 is used. (Parameter No. 6515)
D TOOL COMP.
D Graphic method
D Ridge drawing
D Display mode
D Cross section position
change