
L
t
+
3
0.0394
+ 76.75[m]
B–63443EN/02
7. CONNECTION TO CNC PERIPHERALS
HARDWARE
99
The manual pulse generator cable can be up to 50 m in length.
The power supply to the manual pulse generator is 5 VDC, same as for
the pulse coder. It is therefore necessary to prevent cable resistance from
causing the supply voltage to drop more than 0.2 V (total for both the 0
V and 5 V lines).
This is written as:
0.2 y
0.1 R 2L
m
0.1 : 0.1 A power supply current of the manual pulse generator
R : Resistance per unit length of the wire (Ω/m)
m : Number of wires connected in each 0 V and 5 V line
L : Wire length (m)
This can be converted to the following equation:
L x
m
R
In the case of the A66L–0001–0286 cable, for example, when three pairs
of signal wires and six power supply wires (20/0.18, 0.0394 W/m) are
used (three power supply wires connected to 5 V and the other three to 0
V when one manual pulse generator is used), the cable length is:
However, the maximum pulse transmission distance for the manual pulse
generator is 50 m.
The relationship between the HAn and HBn signals and the Power Mate
pulses shall be as shown in Fig. 7.4.3 (a).
Pulse cycle T
1
is 200 msec or more. Pulse cycle T
1
/4 is 50 msec or more.
t
1
HAn
HBn
T
1
4
T
1
T
1
44
T
1
– direction
pulse
+ direction
pulse
Forward rotation
Click point
Reverse direction
Backward rotation
Fig. 7.4.3 (a)
7.4.3
Cable Connection for
the Manual Pulse
Generator
7.4.4
Signal Requirements
D Pulse width