
B–63443EN/02
H. DESCRIPTION OF PARAMETERS
APPENDIX
299
1601 NCI
(Bit)#7 #6 #5 #4 #3 #2 #1 #0
Data type: Bit
NCI Imposition check at deceleration
0: Performed
1: Not performed
1610 JGLx CTLx
(Bit)#7 #6 #5 #4 #3 #2 #1 #0
Data type: Bit axis
CTLx Acceleration/deceleration (in each axis) in cutting feed
including feed in dry run
0: Exponential acceleration/deceleration is applied.
1: Linear acceleration/deceleration after interpolation is
applied.
JGLx Acceleration/deceleration in manual continuous feed (jog
feed).
0: Exponential acceleration/deceleration is applied.
1: Linear acceleration/deceleration after interpolation is
applied (depending on which is used in cutting feed).
1620
Time constant T used in linear acceleration/deceleration in rapid traverse
for each axis
Data type: Word axis
Unit of data: msec
Valid data range: 0 to 4000
Specify a time constant used in acceleration/deceleration in rapid
traverse.
Feedrate
Time
TT
0
<Linear acceleration/deceleration during rapid traverse>
Rapid
traverse rate
T: Time constant for linear acceleration/deceleration
Set the value when the rapid traverse rate is 100%.
If it is under 100%, the total time is reduced. (Constant acceleration
method)
H.7
PARAMETERS OF
ACCELERATION/
DECELERATION
CONTROL