
B–63443EN/02
H. DESCRIPTION OF PARAMETERS
APPENDIX
291
1201 WZR AWK ZPI ZPR
(Bit)#7 #6 #5 #4 #3 #2 #1 #0
Data type: Bit
ZPR Automatic setting of a coordinate system when manual return
to the reference position is performed
0: Not set automatically
1: Set automatically
NOTE
ZPR is enabled when a workpiece coordinate system is not
selected (bit 0 (WKC) of parameter No. 1204 is 0). When
a workpiece coordinate system is selected, it is always
established according to the workpiece origin offset
(parameter Nos. 1220 to 1226) upon manual return to the
reference position, regardless of the setting of this
parameter.
ZPI Coordinates at the reference position when a coordinate
system is set automatically
0: Value set in parameter 1250 is used.
1: For input in mm, the value set in parameter 1250 is used,
or for input in inches, the value set in parameter 1251 is
used.
This bit is ineffective, when a workpiece coordinate system
option is provided, however.
AWK When the workpiece zero point offset value is changed
0: The absolute position display changed when the next
bufforing block is performed.
1: The absolute position display is changed immediately.
Changed value is valid ofter baffering the next block.
WZR Upon reset, the workpiece coordinate system is:
0: Not returned to that specified with G54
1: Returned to that specified with G54
1202 G50
(Bit)#7 #6 #5 #4 #3 #2 #1 #0
Data type: Bit
G50 When the workpiece coordinate systems is enabled, if the G50
command for setting a coordinate system (or the G92
command in G command system B or C) is specified,
0 : G50 is executed and no alarm is issued.
1 : G50 is not executed and a P/S alarm (No. 010) is issued.
H.4
PARAMETERS OF
COORDINATES