
B–63443EN/02
H. DESCRIPTION OF PARAMETERS
APPENDIX
285
Two combinations of parameters to specify the input/output device data
are provided.
The following shows the interrelation between the reader/punch interface
parameters for the channels.
0020
I/O CHANNEL
Input/output channel number (parameter 0020)
I/O CHANNEL=0
(channel 1)
0101 Stop bit and other data
0102 Number specified for the input/output device
0103 Baud rate
0111 Stop bit and other data
0112 Number specified for the input/output device
0113 Baud rate
I/O CHANNEL=1
(channel 1)
Specify a channel for
an input/output device.
I/O CHANNEL
=0 : Channel 1
=1 : Channel 1
Fig.H.2 I/O Channel Number Settings
(1) Parameters common to all channels
0100 ENS NCR CTV
(Bit)#7 #6 #5 #4 #3 #2 #1 #0
Setting entry is acceptable.
Data type: Bit
CTV Character counting for TV check in control-out state (or
comment part).
0: Performed
1: Not performed
NCR Output of the end of block (EOB) in ISO code
0: LF, CR, CR are output.
1: Only LF is output.
ENS Action taken when a NULL code is found during read of
EIAcode
0: An alarm is generated.
1: The NULL code is ignored.
(2) Parameters for channel 1 (I/O CHANNEL=0)
0101 NFD ASI SB2
(Bit)#7 #6 #5 #4 #3 #2 #1 #0
Data type: Bit
SB2 The number of stop bits
0: 1
1: 2
ASI Code used at data input
0: EIA or ISO code (automatically distinguished)
1: ASCII code
H.2
PARAMETER OF
READER/PUNCH
INTERFACE