9. DIGITAL SERVO
B–63525EN/02
680
AMPLIFIER MAINTENANCE O1000 N00001
AXIS NAME EDITION TEST MAINTE–NO.
1 X 01A 010123 01
2 Y 01A 010123 01
3 Z 01A 010123 01
4 A 02B 010123 01
5 B 02B 010123 01
6 C 02B 010123 01
MDI **** *** *** 13:11:56
[ AMP ][ AXIS ][ MAINTE ][ ][ ]
The amplifier maintenance screen displays the following items:
D AXIS (controlled axis number)
D NAME (controlled axis name)
D AMP (type of amplifier connected to each axis)
D SERIES (servo amplifier series of an amplifier connected to each axis)
D UNIT (unit type of a servo amplifier connected to each axis)
D AXES (maximum number of axes controlled by an amplifier
connected to each axis)
D CUR. (maximum rating for amplifiers connected to each axis)
D EDITION (unit version number of an amplifier connected to each axis)
D TEST (date of test performed on an amplifier connected to each axis)
Example) 010123 = January 23, 2001
D MAINTE–NO. (engineering change number for an amplifier
connected to each axis)
On an FSSB setting screen (other than the amplifier maintenance screen),
pressing soft key [(OPRT)] displays the following soft keys:
SET INPUTREAD
To enter data, place the machine in MDI mode or the emergency stop state,
position the cursor to the point where a desired item is to be input, then
enter the desired data and press soft key [INPUT] (or the
INPUT
key on the
MDI panel).
When soft key [SET] is pressed after data has been entered, a warning
message is displayed if the entered data contains an error. When the data
is satisfactory, the corresponding parameter is set up.
To restore the previous value of a parameter if, for example, an entered
value is incorrect, press soft key [READ].
When the power is turned on, values are read from the parameters and
displayed on the screen.
D Setting