B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
909
Fig. B.1.1.1 (c)
[ROUGH O.D.] Press this key for roughing of outer figure. . .
[S–FIN O.D.] Press this key for semi–finishing of outer figure. . . . .
[FIN O.D.] Press this key for finishing of outer figure. . . . . . .
[ROUGH I.D.] Press this key for roughing of inner figure. . . .
[S–FIN I.D.] Press this key for semi–finishing of inner figure. . . . . .
[FIN I.D.] Press this key for finishing of inner figure. . . . . . . .
[BAR FEED] Press this key to perform bar feed machining.. . . . .
[SUB CYCLE] Press this key for sub cycle. . . .
Fig. B.1.1.1 (d)
[GROOVE NECK] Press this key for grooving (rough grooving or. . .
rough grooving and finishing are carried out by
a single tool) or necking.
[ROUGH GROOVE] Press this key for rough grooving. .
[FIN GROOVE] Press this key for grooving finishing. . . . . .
[CUT OFF] Press this key for corner cutting (When the. . . . . . . . .
system parameter No.140 is 0, this soft key is
not displayed.)
[THREADING] Press this key for thread cutting. . . . . .
[SUB CYCLE] Press this key for sub cycle. . . . . . .
Fig. B.1.1.1 (e)
[C–AXIS C.DRIL] Press this key for C–axis center drilling. . . .
[C–AXIS DRILL] Press this key for C–axis drilling. . . .
[C–AXIS TAP.] Press this key for C–axis tapping. . . . . .
[C–AXIS GROOV.] Press this key for C–axis grooving. . .
[C–AXIS F.MILL] Press this key for face milling. . . .
[SUB CYCLE] Press this key for sub sycle. . . . . . .
[C–AXIS S.MILL] Press this key for cylindrical grooving. . . .
For example, press “Rough O.D.” when the soft key in Fig. B.1.1.1 (c)
is displayed; “Roughing of outer figure” will have been selected in
process No.1.