B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
961
NOTE
When a drilling tool with the diameter equal to the inside
diameter width is used, no inside diameter machining is
performed even when inside diameter machining operation
has been set in the machining procedure setting.
In Fig. B.2.4 (d) example, no inside diameter machining
process itself is generated.
In Fig. B.2.4 (e) example, inside diameter machining is
generated, but it is only in the region where the starting point
is A and the end point is B.
Fig. B.2.4 (d) Fig. B.2.4 (e)
NOTE
When the starting point of inside diameter cutting is on the
outside diameter of meterial as shown in Fig. B.2.4 (f) below,
the operation is as follows.
(a)When Drill → I.D is set in the machining procedure data,
drilling process is prepared, but no inside diameter
machining is prepared.
(b)If drilling is not set in the machining procedure data,
inside diameter machining is executed.
Fig. B.2.4 (f)