APPENDIXG. ALARM LIST
B–63534EN/02
1188
Number ContentsMessage
5044 G68 FORMAT ERROR The G68 block contains a format error. This alarm occurs in the fol-
lowing cases:
1 One of I, J, and K is not specified in the G68 block (missing option
for coordinate conversion).
2 I, J, and K are 0 in the G68 block.
3 R is not specified in the G68 block.
5046 ILLEGAL PARAMETER (ST.COMP) An illegal parameter has been specified for straightness compensa-
tion.
Possible reasons are as follows:
1 There is no axis corresponding to the axis number specified in the
move axis or compensation axis parameter.
2 More than 128 pitch error compensation points are not sequentially
numbered.
3 The straightness compensation points are not sequentially num-
bered.
4 A specified straightness compensation point is outside the range
between the pitch error compensation points having the maximum
positive and negative coordinates.
5 The compensation value specified for each compensation point is
too large or too small.
6 The settings of parameters Nos. 13881 to 13886 are illegal.
5050 ILL–COMMAND IN CHOPPING
MODE
When the chopping function is used, a move command was specified
for a chopping axis in chopping mode (during reciprocation between
a top dead point and bottom dead point).
5051 M–NET CODE ERROR When the chopping function is used, a move command was specified
for a chopping axis in chopping mode (during reciprocation between
a top dead point and bottom dead point).
5052 M–NET ETX ERROR “ETX” code is abnormal.
5053 M–NET CONNECT ERROR Connection time supervision error (parameter No.175)
5054 M–NET RECEIVE ERROR Boring time supervision error (parameter No.176)
5055 M–NET PRT/FRM ERROR Vertical parity or framing error detection
5057 M–NET BOARD SYSTEM DOWN Transmit time–out error (parameter No. 177)
ROM parity error
CPU interruption detection of not listed above
5060 ILLEGAL PARAMETER IN
G02.3/G03.3
Parameter setting is illegal.
No. 5641 (setting of the linear axis) is not specified.
No. 5641 specifies an axis other than a linear axis.
No. 5642 (setting of the rotation axis) is not specified.
No. 5642 specifies an axis other than a rotation axis.
The CNC cannot control the linear or rotation axis (the value of No.
1010 is exceeded).
5061 ILLEGAL FORMAT IN G02.3/G03.3 The command for exponential interpolation (G02.3/G03.3) contains a
format error.
Address I, J, or K is not specified.
Addresses I, J, and K are 0.
5062 ILLEGAL COMMAND IN
G02.3/G03.3
The command for exponential interpolation (G02.3/G03.3) contains
an illegal value.
The specified value is not suitable for exponential interpolation (for
example, a negative value is subject to ln).