PROGRAMMING22. RISC PROCESSOR
B–63534EN/02
690
– Small–hole peck drilling cycle –G83
– Changing workpiece coordinate system
–G92
– workpiece coordinate system preset –G92.1
– Feed per revolution –G95
– Constant surface speed control –G96,G97
– Infeed control –G160,G161
– NURBS interpolation –G06.2
– Workpiece coordinate system –G54,G54.1,G55,G56,G57,
G58,G59
– M,S,T and B functions with motion command
In the mode for this function, the following functions cannot be used, The
warning message is displayed on the screen when the following functions
are used. :
– MDI intervention
In the mode for this function, the following functions cannot be used, The
alarm(P/S5196) is issued when the following functions are used. :
– Manual interruption operation
– Tool retract and recover
And , in the mode for this function, the following functions cannot be
used.
– Flexible synchronous control
– Sequence number comparison and stop
(The program is not stop at the specified sequence block in 3
dimensional cutter compensation mode.)
– Index table indexing
– Retrace function
Retrace function cannot be used by the program which uses 3
dimensional cutter compensation.
– Rotary axis control
– Gentle normal direction control
– Thc command for the tool life management function
(Tool life time is able to be counted in this mode, but the command for
the tool life management function cannot be used.)
– Macro executor ( Execution macro )
– Manual handle interruption operation
– External deceleration
External decelaration is not available in this mode.
3 dimensional cutter compensation function cannot be used with the
following function.
– Angular axis control
– Arbitrary angular axis contol
The limitation attaches about the combination of other NC instructions
occasionally.
Please refer to the manual of the each function.
D Function that cannot be
specified
D Others