APPENDIXG. ALARM LIST
B–63534EN/02
1190
Number ContentsMessage
5115 SPL : ERROR There is an error in the specification of the rank.
No knot is specified.
The knot specification has an error.
The number of axes exceeds the limits.
Other program errors
5116 SPL : ERROR There is a program error in a block under look–ahead control.
Monotone increasing of knots is not observed.
In NURBS interpolation mode, a mode that cannot be used together is
specified.
5117 SPL : ERROR The first control point of NURBS is incorrect.
5118 SPL : ERROR After manual intervention with manual absolute mode set to on, NURBS
interpolation was restarted.
5122 ILLEGAL COMMAND IN SPIRAL A spiral interpolation or conical interpolation command has an error.
Specifically, this error is caused by one of the following:
1) L = 0 is specified.
2) Q = 0 is specified.
3) R/, R/, C is specified.
4) Zero is specified as height increment.
5) Three or more axes are specified as the height axes.
6) A height increment is specified when there are two height axes.
7) Conical interpolation is specified when the helical interpolation
function is not selected.
8) Q < 0 is specified when radius difference > 0.
9) Q > 0 is specified when radius difference < 0.
10) A height increment is specified when no height axis is specified.
5123 OVER TOLERANCE OF END
POINT
The difference between a specified end point and the calculated end
point exceeds the allowable range (parameter 3471).
5124 CAN NOT COMMAND SPIRAL A spiral interpolation or conical interpolation was specified in any of the
following modes:
1) Scaling
2) Programmable mirror image
3) Polar coordinate interpolation
In cutter compensation C mode, the center is set as the start point or
end point.
5134 FSSB : OPEN READY TIME OUT Initialization did not place FSSB in the open ready state.
5135 FSSB : ERROR MODE FSSB has entered error mode.
5136 FSSB : NUMBER OF AMPS IS
SMALL
In comparison with the number of controlled axes, the number of amplifi-
ers recognized by FSSB is not enough.
5137 FSSB : CONFIGURATION ERROR FSSB detected a configuration error.
5138 FSSB : AXIS SETTING NOT COM-
PLETE
In automatic setting mode, axis setting has not been made yet.
Perform axis setting on the FSSB setting screen.
5139 FSSB : ERROR Servo initialization did not terminate normally.
The optical cable may be defective, or there may be an error in connec-
tion to the amplifier or another module.
Check the optical cable and the connection status.
5155 NOT RESTART PROGRAM BY G05 During servo leaning control by G05, an attempt was made to perform
restart operation after feed hold or interlock. This restart operation can-
not be performed. (G05 leaning control terminates at the same time.)