OPERATIONB–63534EN/02 9. EDITING PROGRAMS
971
6 Select one or more programs to be copied.
⋅ Single–program copy
(1)Enter the number of the program to be copied.
→ ” ”
(2)Press soft key
[SOURCE] to set the number.
→ SOURCE:PATH?=” ”
⋅ Specified–range copy
(1)Enter the range of the programs to be copied, as a number.
→ ” –VVVV”
[Entry format] –VVVV
Range symbol
Range end (largest) number
Range start (smallest) number
(2)Press soft key
[SOURCE] to set the number.
→ SOURCE:PATH?=” –VVVV”
⋅ To cancel the selection of the program(s) to be copied, press
[SOURCE] again.
7 Select the copy destination number.
The selected program(s) can be copied by assigning numbers other
than their original numbers.
(1)Type the destination number.
→ ”∆∆∆∆”
(2)Press soft key
[DEST] to set the number.
→ DEST:PATH?=”∆∆∆∆”
⋅ Pressing
[DEST] without entering any number causes the original
program number(s) to be used as is.
⋅ To cancel the set number, press
[DEST] again.
⋅ For specified–range copy, the set number is assigned to the first
program of the specified range. The subsequent programs are
assigned numbers obtained by repeatedly incrementing the set
number by one.
8 Specify replacement.
If any number to be assigned to a program to be copied is already
being used for a program registered for the destination path, specify
whether the existing program is to be replaced with that to be copied.
If replacement is currently disabled, pressing soft key
[REPLACE]
enables replacement. Pressing [REPLACE] repeatedly toggles
between replacement being enabled and disabled.
”REPLACE=ON” indicates that replacement is enabled.
”REPLACE=OFF” indicates that replacement is disabled.
9 Press soft key
[EXEC] to start copying.