2.DEVELOPMENT OF CUSTOM SCREEN B-66284EN/01
- 206 -
Signal Address:
Specify the address of the 7-background color selection signal
for the numeral indication section. This signal requires one byte
if 0:PMC (bit) is specified for Type. As the background color, bit
0 takes precedence. If blink bit 7 turns on, blinking starts with
the specified on and off colors.
If 1:PMC (big or small comparison) is specified for Type, a
continuous area with the length specified as the data length (1, 2,
or 4 bytes) is required.
Set Up Number:
If specifying 1:PMC (big or small comparison) for Type, specify
the number of change beginning values to be used.
This option is not used if 0:PMC (bit) is specified for Type.
Data Length:
If specifying 1:PMC (big or small comparison) for Type, specify
the data length of the PMC area specified with the signal area
and the signal address.
0: 1 Byte (Signed)
1: 1 Byte (Unsigned)
2: 2 Bytes (Signed)
3: 2 Bytes (Unsigned)
4: 4 Bytes (Signed)
5: 4 Bytes (Unsigned)
This option is not used if 0:PMC (bit) is specified for Type.
Use Blink Signal:
Check this box to use blinking in the numeral indication section.
This option takes effect if 1:PMC (big or small comparison) is
specified for Type.
Blink Signal Area:
Specify the type of the address of the PMC signal used to specify
the blinking in the numeral indication section. The following
areas can be specified:
R, D, K, X, Y, G, F, E(PMC-SB7)
This option takes effect if 1:PMC (big or small comparison) is
specified for Type.
Blink Signal Address:
Specify the address of the blink signal.
This option takes effect if 1:PMC (big or small comparison) is
specified for Type.
Blink Signal Bit:
Specify the bit position of the signal address above by using a
number 0 to 7.
This option takes effect if 1:PMC (big or small comparison) is
specified for Type.
Light Color #6 to #0:
Specify the ON color corresponding to each of the bits.
Character Color #6 to #0:
Specify the numeral indication character color corresponding to
each of the bits.