4.DESCRIPTION OF PARAMETERS B-63790EN/01
- 100 -
1536 Time required to reach the maximum acceleration of pre-interpolation bell-
shaped acceleration/deceleration (for finishing)
[Input type] Parameter input
[Data type] Integer
[Unit of data] msec
[Valid data range] 0 - 200
Stores the pre-interpolation bell-shaped acceleration/deceleration time
constant for the finishing parameter set. Usually, the time constant is
entered from the HPCC (SETTING) screen. If a different value needs
to be set for an axis, this parameter must be directly specified. To
make the setting effective during operation, the "SELECT ACTIVE"
key must be pressed on the HPCC (SETTING) screen.
1539 Acceleration/deceleration reference speed (for finishing) for the bell-shaped
acceleration/deceleration time constant change function
[Input section] Setting input
[Data type] Real type
[Unit of data] mm/min, inch/min, degrees/min (input unit)
[Minimum data unit] Follows the increment system of the reference axis.
[Data range] See the standard parameter setting table (C).
(0.0 to +240000.0 for the IS-B)
This parameter is used if the bell-shaped acceleration/deceleration
time constant change function is used.
It stores the acceleration/deceleration reference speed for the finishing
parameter set. Usually, enter the speed from the High-speed High-
precision Machining Setting Screen. For the setting to take effect
during operation, either click the "Active selection" key on the High-
speed High-precision Machining Setting Screen or issue the
G05.1Q1Rx command using a program.
1540 Finishing level (for medium finishing)
[Input type] Parameter input
[Data type] Integer
[Valid data range] 0 - 100
Stores the finishing level for the medium machining parameter set.
Usually, the level is entered from the HPCC (SETTING) screen and,
therefore, this parameter need not be directly specified.