4.DESCRIPTION OF PARAMETERS B-63790EN/01
- 60 -
1031 Reference axis
[Input type] Parameter input
[Data type] Integer
[Valid data range] 0 - Max axes
The units of parameters common to all axes, such as the dry run
feedrate and feedrate specified by code F with one digit, vary
according to the increment system. In the Series 15, the effective
increment system for each axis is selected using a parameter. The
units of these parameters must match the increment system of the
reference axis. Select the axis to use as the reference axis.
1032 Designation of axis (linear axis) used for polar coordinate interpolation
[Input type] Parameter input
[Data type] Integer
[Valid data range] 1 - Max axes
Set the number of the linear control axis used for polar coordinate
interpolation.
1033 Destination of axis (rotation axis) used for polar coordinate interpolation
[Input type] Parameter input
[Data type] Integer
[Valid data range] 1 - Max axes
Set the number of the rotation control axis used for polar coordinate
interpolation.
1038 Reserved parameter for customer’s board
NOTE
After specifying this parameter, turn the power off, and
then on again, for the new setting to take effect.
[Input type] Parameter input
[Data type] Integer axis
[Valid data range] 0 - Max axes
1039 Reserved parameter for customer’s board
NOTE
After specifying this parameter, turn the power off, and
then on again, for the new setting to take effect.
[Input type] Parameter input
[Data type] Integer axis
[Valid data range] 0 - Max axes