B--63003EN--1/02
2. PREPARATIONS FOR OPERATION
293
NOTE
1 Spindle motor speed detection is enabled only for serial
spindles.
2 The relationship between servo motor speed detection
signals DSV1 to DSV8 and the servo motors depends on
the servo axis number (servo connector number) set in
parameter No. 1023.
3 When two--path control is applied, commands can be
switched between the paths by using composite control (T
series) or S command selection.
Even when such command switching is performed, the
relationship between detection signals DSV1 to DSV8,
DSP1, DSP2, and DSP3 and the motors remains as is. (The
relationship is determined as described in Note 2 above.)
Note