B--63003EN--1/02
8. AUXILIARY FUNCTION
693
This function checks whether combinations of M codes (up to three)
specified in one block are correct.
The function has two purposes. One of the purposes is to alarm if an M
code which must not be combined with any other M codes is combined
with another. The other purpose is to alarm if an M code in a group is
combined with another M code in the same group. These errors are
reflected in P/S alarm No. 5016.
Pressing the
SYSTEM
key, then the continuous menu key several times causes
the [M CODE] soft key to appear. Pressing this soft key displays the
screen shown in Fig. 8.6 (a).
MDI
**** *** ***
00 : 00 : 00
M CODE GROUP SETTING O0000 N0000
NO. MCG NO. MCG NO. MCG
0000 0 0010 0 0020 0
0001 0 0011 0 0021 0
0002 0 0012 0 0022 0
0003 0 0013 0 0023 0
0004 0 0014 0 0024 0
0005 0 0015 0 0025 0
0006 0 0016 0 0026 0
0007 0 0017 0 0027 0
0008 0 0018 0 0028 0
0009 0 0019 0 0029 0
>
(OPRT)MCODE
Fig. 8.6 (a)
Basically, item numbers correspond to M codes. However, there may be
exceptions depending on parameter setting. (See descriptions of the
relevant parameters.) The data specified on this screen remains until all
parameters are cleared simultaneously. To go to the next page of the
screen, use the [PAGE] key.
Pressing the [(OPRT)] soft key or the corresponding numeric key displays
the soft keys shown in Fig. 8.6 (b). Searches for the desired item number
and enter the data.
Semicolon “;” may be used for continuous data entry.
Data entry is enabled when PARAMETER WRITE ENABLE is set to “1”
on the parameter setting screen.
>
MDI
**** *** ***
00 : 00 : 00
INPUT
No. SRH
Fig. 8.6 (b)
8.6
M C ODE GROUP
CHECK FUNCTION
General
D Setting the group data