B--63003EN--1/02
9. SPINDLE SPEED FUNCTION
887
Parameter setting
SS3 SS2
er
a
sp
n
es to
euse
¢ ¢
First serial spindle only
¢
f
First and second serial spindles
f
f
First, second, and third spindles
No. 4000 -- 4351: S1 For 1st serieal spindle
S2 For 2nd serial spindle
S3 For 3rd serial spindle
The above parameters are on the CNC, but actually they are used for the
spindle control unit of serial spindle.
For details of these parameters, refer to the following manual:
FANUC AC SPINDLE MOTOR α series PARAMETER MANUAL
(B--65160E)
FANUC SERVO MOTOR ∼ series Maintenance Manual (B--65165E).
#7 #6 #5 #4 #3 #2 #1 #0
3702 OR3
NOTE
After setting this parameter, turn the power off then on again
so that the setting will take effect.
[Data type] Bit type
OR3 Specifies whether to use the stop--position external--setting type spindle
orientation function for the third spindle.
0 : Do not use the function.
1 : Use the function.
NOTE
When the stop-- position external--setting type spindle
orientation function is used, the parameters for setting the
spindle orientation stop position using a position coder
(parameter Nos. 4031 and 4204) are ignored.
D Parameters of se rial
spindle control unit
D Stop--position
external--setting type
spindle orientation