11. PROGRAM COMMAND
B--63003EN--1/02
972
RD2, RD1 Set the axis and direction in which the tool in drilling canned cycle G76 or
G87 is got free. RD2 and RD1 are set as shown below by plane selection.
RD2 RD1 G17 G18 G1 9
0 0 +X +Z +Y
0 1 -- X -- Z -- Y
1 0 +Y +X +Z
1 1 -- Y -- X -- Z
M5T When a spindle rotates from the forward to the reverse direction and vice
versa in tapping cycles G84 and G74 for M series (G84 and G88 for T
series), befor M04 or M03 is output:
For T series
0 : Not output M05
1 : Outputs M05
For M series
0 : Outputs M05
1 : Not output M05
M5B In drilling canned cycles G76 and G87:
0 : Outputs M05 before an oriented spindle stops
1 : Not output M05 before an oriented spindle stops
#7 #6 #5 #4 #3 #2 #1 #0
RDI5102 RAB
[Data type] Bit
RAB The R command for the drilling canned cycle in the Series 15 format is:
0 : Regarded as an incremental command
1 : Regarded as:
An absolute command in the case of G code system A
An absolute command in the case of G code system B or C when the
G90 mode is specified.
An incremental command in the case of G code system B or C when
the G91 mode is specified.
RDI The R command for the drilling canned cycle in the Series 15 format:
0 : Is regarded as the specification of a radius
1 : Follows the specification of a diameter/radius for the drilling axis
#7 #6 #5 #4 #3 #2 #1 #0
5103
SIJ
[Data type] Bit
SIJ A tool shift value for the drilling canned cycle G76 or G87 is specified by:
0 : Address Q
1: AddressI,J,orK