B--63003EN--1/02
7. FEEDRATE CONTROL/ACCELERATION
AND DECELERATION CONTROL
571
NOTE
In the advanced preview control mode, the functions listed
below cannot be specified. To specify these functions,
cancel the advanced preview control mode, specify the
desired function, then set advanced preview control mode
again.
Rigid tapping function
Cs contouring control function
Feed per revolution
One--digit F code feed
Polar coordinate interpolation function
Cylindrical interpolation function
Involute interpolation function
Exponential interpolation
Three -- dimensional coordinate conversion
Retrace function
Normal d irection control
Polar coordinate command
Index table indexing
Tool retract and recover
Threading and synchronous cutting
High-- speed cycle cutting
Handle interruption
Program restart
Simple synchronous control
Feed stop
High --speed skip function
Constant surface speed control
Interrupt type custom macro
Small--hole peck drilling cycle
High--speed remote buffer A/B
Automatic tool length measurement
Skip cutting
G28 (lo w-- speed reference position return)
Series
16i/160i/18i/180i
OPERATOR’S MANUAL
(For Machining Center)
(B--63014EN)
II.19.3 advanced preview CONTROL
(G08)
Series 21i/210i OPERATOR’S MANUAL
(For Machining Center)
(B--63094EN)
II.19.2 advanced preview CONTROL
(G08)
Series 20i OPERATOR’S MANUAL
(For Milling) (B--63384EN)
II.17.1 advanced preview CONTROL
(G08)
Note
Reference item