5. AUTOMATIC OPERAT ION
B--63003EN--1/02
430
During program execution, this function causes a single block stop right
after a block with a specified sequence number is executed.
To use this function, first specify the program number (1 to 9999) of a
program that contains a sequence number where operation is to bestopped
and the sequence number on the setting data screen:
With this setting, a single block stop occurs after the execution of the
block with the specified sequence number during automatic operation.
Setting data
-- SEQUENCE STOP (PROGRAM NO.)
Specify the program number (1 to 9999) of a program to which a
sequence to be stopped belongs.
-- SEQUENCE STOP (SEQUENCE NO.)
Specify the sequence number (1 to 99999) of a sequenceto be stopped.
NOTE
After the specified sequence number is found during the
execution of the program, the sequence number set for
sequence number compensation and stop is decremented
by one. When the power is turned on, the setting of the
sequence number is 0.
Series
16i/160i/18i/180i
OPERATOR’S MANUAL
(For Machining Center)
(B--63014EN)
III.11.4.4 Sequence Number Comparison
and Stop
OPERATOR’S MANUAL
(For Lathe) (B --63004EN)
III.11.4.8 Sequence Number Comparison
and Stop
Series 21i/210i
OPERATOR’S MANUAL
(For Machining Center)
(B--63094EN)
III.11.4.4 Sequence Number Comparison
and Stop
OPERATOR’S MANUAL
(For Lathe) (B --63084EN)
III.11.4.8 Sequence Number Comparison
and Stop
5.6
SEQUENCE NUMBER
COMPARISON AND
STOP
General
Parameter
Note
Reference item