B--63003EN--1/02
7. FEEDRATE CONTROL/ACCELERATION
AND DECELERATION CONTROL
573
Name Function
Absolute/incremental com-
mand
Combined use possible in the block
Sequence number 5digits
Tape code EIA, ISO
Tape format Word address format
Control in/out Yes
Optional block skip Yes
Circle radius R specification Yes
Automatic operation Memory operation, Tape operation
Method of tape operation RS--232--C, RS--422, DNC1, and remote
buffer
Manual absolute on/off Yes (FS15 type)
Cycle start, Feed hold Yes
Dry run Yes
Feedrate override under dry
run
0 -- 655.34%, Every 0.01%
Single block Yes
Inch/metric conversion Yes (Unchangeable in G05P10000 mode)
Multi--buffer Yes
Cutter compensation C Yes
Interlock (all axes) Yes
Machine loc k Yes
Subprogram call (M98, M198) Yes (Usable with parameter MSU (No.
8403#1)=1)
Auxiliary function Yes (Usable with parameter MSU (No.
8403#1)=1)
Scaling Provided (when bit 0 (G51) of parameter No.
8485 is set to 1)
Coordinate rotation Provided (when bit 0 (G51) of parameter No.
8485 is set to 1)
Canned drilling cycle Provided (when bit 1 (G81) of parameter No.
8485 is set to 1)
Rigid tapping Provided (when bit 1 (G81) of parameter No.
8485 is set to 1)
G00 : Positioning (Note)
G01 : Linear interpolation
G02 : Circular interpolation, Helical interpolation (CW) (Note)
G03 : Circular interpolation, Helical interpolation (CCW) (Note)
G02.2 : Involute interpolation (CW) (Note)
G03.2 : Involute interpolation (CCW) (Note)
G17 : Plane selection (XpYp plane)
where, Xp is the X--axis or its parallel axis;
D Data that can be
specified