
B-63423EN/02 USER PROGRAM 14. USER WINDOW PROGRAMS
-99-
Variable Description
+0 Number of submenus of the user cycle machining menu
+1 Number of the string definition macro for the user cycle
machining menu
+2 Number of submenus of user cycle machining menu 1
+3 Number of the string definition macro for user cycle
machining menu 1
+4 Number of the attribute data macro for user cycle machining
menu 1
+5 Number of the guidance drawing figure macro for user cycle
machining menu 1
+6 Number of the input data check macro for user cycle
machining menu 1
+7 Number of submenus of user cycle machining menu 2
+8 Number of the string definition macro for user cycle
machining menu 2
+9 Number of the attribute data macro for user cycle machining
menu 2
+10 Number of the guidance drawing figure macro for user cycle
machining menu 2
+11 Number of the input data check macro for user cycle
machining menu 2
+12 Number of submenus of user cycle machining menu 3
+13 Number of the string definition macro for user cycle
machining menu 3
+14 Number of the attribute data macro for user cycle machining
menu 3
+15 Number of the guidance drawing figure macro for user cycle
machining menu 3
+16 Number of the input data check macro for user cycle
machining menu 3
+17 Number of submenus of user cycle machining menu 4
. . . . . .
NOTE
Define the string definition macros, attribute data
macros, guidance drawing figure macros, and
input data check macros in the same way as those
for cycle machining.
2) Starting the data input screen using a soft-key in the machining
menu
Normally, when a soft-key is pushed in the machining menu, the
corresponding soft-keys are displayed in the detail menu. Then,
the data input screen appears when one of the soft-keys is pushed.
However, when the number of submenus of the machining menu
is defined as -1, as shown below, pushing a soft-key in the
machining menu can display the corresponding data input
window.
Number of submenus of user cycle machining menu m = -1
Number of the string definition macro for the user-defined
machining menu = Any