
B-63423EN/02 USER PROGRAM 16. MEASUREMENT CYCLE
-107-
16.2 CALIBRATION AND MEASUREMENT CYCLES
By pushing the [CYCLE] in the editing menu, the cycle menu below
is displayed.
HOLE PATTER FACING SIDE CU
TTING
POCKET
ING
CALIBR
ATION
MEASU
R
RETURN
CALIBRATION : Define calibration cycles for the touch probe.
MEASUR : Define measurement cycles.
NOTE
The number (O730n) of this user program is set for
the number of the string definition macro for the
cycle machining menu, in the startup macro
program.
O730n ;
N0001 (“20 01 C010 20”) (Alphanumeric letters for HOLE) ;
Maximum 6ch
N0002 (“20 01 C018 20”) (Alphanumeric letters for PATTER) ;
Maximum 6ch
N0003 (“20 01 C020 20”) (Alphanumeric letters for FACING) ;
Maximum 6ch
N0004 (“20 01 C028 20”) (Alphanumeric letters for SIDE CUTTING) ;
Maximum 6ch
N0005 (“20 01 C030 20”) (Alphanumeric letters for POCKETING) ;
Maximum 6ch
N0006 (“20 01 C038 20”) (Alphanumeric letters for CALIBRATION) ;
Maximum 6ch
N0006 (“20 01 C040 20”) (Alphanumeric letters for MEASUR) ;
Maximum 6ch
By pushing the [CALIB] in the editing menu, the calibration menu
below is displayed.
PROBE DIA. OFFSET
A
OFFSET
B
戻り
Pushing a soft-key displays the corresponding menu in a pop-up
window. This section assumes that [PROBE] is pushed. The
following uses an example of the probe menu for explanation.