
8. DATA STRUCTURE OF MACHINING PROGRAM
USER PROGRAM B-63423EN/02
-58-
NOTE
1. The first variable number is specified by
parameter No.9102. Standard value is # 6070.
2. The number of user program, which is specified
the attribute data, is the number of “Macro program
number for defining Data Attribute” in Start-up
macro program.
The program number of each menu is increased
by 1.
2-1. Macro program number for defining Data
attribute of G-code menu = 8402
(1). INITIAL SET = O8402
(2). TOOL SET = O8403
(3). MSF CODE = O8404
(4). COMP. = O8405
(5). POSITIONING = O8406
2-2. Macro program number for defining Data
attribute of Contour menu = 8411
(1). START POINT = O8411
(2). LINE = O8412
(3). CIRCLE CW = O8413
(4). CIRCLE CCW = O8414
(5). CHANFERING = O8415
(6). CORNER R = O8416
(7). END = O8417
(8). TRANS COPY = O8418
(9). ROTATE COPY = O8419
(10). MIRROR COPY = O8420
2-3. Macro program number for defining Data
attribute of Hole machining menu = 8432
(1). DORILLING = O8432
(2). BORING = O8433
(3). TAPPING = O8434
2-4. Macro program number for defining Data
attribute of Hole pattern menu = 8451
(1). POINTS = O8451
(2). LINE = O8452
(3). GRID = O8453
(4). SQUARE = O8454
(5). CIRCLE = O8455
(6). ARC = O8456
2-5. Macro program number for defining Data
attribute of Facing menu = 8461
(1). SQUARE SURFACE = O8461
(2). CIRCLE SURFACE = O8462