
3. USER PROGRAMS FOR G-CODE MENU
SAMPLE PROGRAM B-63423EN/02
-160-
N0010(' subrogram');
N0011('M99:End of subrogram');
; Contour/Line : Start Point Type
N0020('When you make the');
N0021('island figure after the');
N0022('pocket wall figure,');
N0023('select "ISLAND". ');
N0024('');
N0025('When you continue');
N0026('making the next groove');
N0027('figure,');
N0028('select "NXT MV".');
N0029('');
N0030('Another case,');
N0031('select "START".');
; Contour/End
N0040('When you continue');
N0041('making the contour');
N0042('figure, select "CONT".');
N0043('(Example)');
N0044('The case of making the');
N0045('island figure after the');
N0046('pocket wall figure.');
N0047('The case of making some');
N0048('groove figures.');
; Contour/Linear,Rotation,Mirror Copy
N0060('START'); ; Linear
N0061('POINT');
N0062('END');
N0063('POINT');
N0064('START');
N0065('POINT');
N0066('END');
N0067('POINT');
N0068('BASE');
N0069('AXIS');
; Canned Cycle
N0080('Initial');
N0081('level');
N0082('Point R');
N0083('level');
; Contour : Approach/Escape Type
N0090('Circle');
N0091('Tangent');
N0092('Vertical');
; Canned Cycle
N0101('G81:No dwell');
N0102('G82:With dwell');
N0103('G83:Normal peck');
N0104('G73:High-speed peck');
N0105('G85:Feed retraction');
N0106('G86:Rapid retraction');
N0107('G88:Manual retraction');
N0108('G89:With dwell');
N0109('G76:Fine boring');
N0110('G87:Back boring');
N0111('G84:Tapping');
N0112('G74:Left-hand tapping');
; Contour : Compensation Direction
N0121('Left');