
B-63423EN/02 SAMPLE PROGRAM
4. USER PROGRAMS FOR CONTOUR PROFILE MENU
-203-
; Canned Cycle
N0080('Initial');
N0081('level');
N0082('Point R');
N0083('level');
; Contour : Approach/Escape Type
N0090('Circle');
N0091('Tangent');
N0092('Vertical');
; Canned Cycle
N0101('G81:No dwell');
N0102('G82:With dwell');
N0103('G83:Normal peck');
N0104('G73:High-speed peck');
N0105('G85:Feed retraction');
N0106('G86:Rapid retraction');
N0107('G88:Manual retraction');
N0108('G89:With dwell');
N0109('G76:Fine boring');
N0110('G87:Back boring');
N0111('G84:Tapping');
N0112('G74:Left-hand tapping');
; Contour : Compensation Direction
N0121('Left');
N0122('Right');
; CHECK*.SRC message
N0900('Data is lacking.');
N0901('Input error in menu param.');
M99